Morgan & Company HEARTHSTONE 8470 User Manual download pdf (Page 10)

Clearances to NFPA 211 Protected Surfaces

You can reduce the clearances to combustible surfaces by

using any National Fire Protection Agency (NFPA)

approved wall protection system. Please refer to NFPA

211 for specifications and complete details. You can

obtain this information directly from NFPA.

Clearances to combustible surfaces can be reduced by

using any NFPA approved wall protection system.

REFER TO NFPA 211 FOR SPECIFIC AND

COMPLETE DETAILS:

National Fire Protection Agency

Battery March Park

Quincy, MA 02269

1-800-344-3555

1-617-770-3000

CLEARANCE TO COMBUSTIBLES

COMBUSTIBLE MANTLE

SIDE WALL

SIDE

TRIM

Figure 5 Clearance to Combustibles

A. side wall = 13”

B. mantle and top trim = 34”

B. mantle/ with mantle shield kit = 22”

C. trim = 3”

REMOVING THE BAFFLE

In order to connect the flue to the Morgan, you will need

to remove and install the baffle. Use Figure 6 to refer to

while removing and replacing the baffle.

BE CAREFUL WHEN HANDLING THE BAFFLE,

NOT TO PUNCTURE THE CERAMIC BOARD

To remove the baffle:

1. Lift the front of the baffle. This relieves the

weight from, and unlocks the shelf tabs.

2. Pull forward to free the baffle.

3. The baffle should now be free to drop down and

pull out of the front door, or rest on the floor of

the insert

Once the baffle is removed from the unit, you will have

direct access to the flue collar, and all venting connections

To install the baffle, reverse the order of removing the

baffle.

Shelf tabs

Baffle

sleeves

Figure 6 Baffle Placement

ENTING COMPONENTS AND CONFIGURATION

It is very important to follow minimum clearances for

chimney connectors to combustibles such as walls and

ceilings when installing the stove near non-

combustible surfaces

• Single wall connector is 24 MSG or 25 MSG blued

steel stovepipe.

• Double wall connector (close clearance pipe) which

must be used with a listed factory-built “Type HT"

chimney also may be used with a masonry chimney to

reduce clearances, is available from several

manufacturers, your dealer can help you choose.

Some air insulated connector pipe models available

are Simpson Dura Vent DVL and Metalbestos DS.

Security, GSW and Ameritec also have acceptable

close clearance connector pipe.

• Chimney connector shall not pass through floor or

ceiling, nor any attic or roof space, closet or similar

concealed space. Where passage through a wall or

partition of combustible construction is desired, the

installation shall conform to NFPA 211 or CAN/CSA

- B365.

HearthStone Quality Home Heating Products, Inc. ® Morgan Model 8470

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

Comments to this Manuals

No comments

Morgan & Company HEARTHSTONE 8470 User Manual Page 10

Comments to this Manuals